6-112
6.5.11 System configuration definition
For the MICREX-SX series, you need to use the programming support tool Expert (D300win) to
construct the system, configure the entire system for operation, set operation, and set individual modules.
The following describes how to configure the system definition of the inverter, which is connected to the
SX bus as a slave module. For configuration of the PC, memory, program, and other individual modules
than the inverter, refer to each user's manual of the corresponding MICREX-SX series product.
6.5.11.1 Programming support tool expert (D300win)
D300win is program creation system software for the MICREX-SX series. Note that you must use
particular versions of D300win to configure the system definition of FRENIC-VG. Use a version shown
below (or later). Screenshots may differ depending on the version used.
Expert (D300win) Version
V3 series: 3.0.0.0 or later
V2 series: 2.2.2.0 or later
Note: If you have a (registered) version of
D300win which does not support
FRENIC-VG, contact our sales
personnel to upgrade it. You can
check the current version of
D300win by choosing [Information]
from the [Help] menu.
Figure 6.5.27
Note
When configuring the system definition including VG1, set the SX bas tact to 1 ms or longer.
D300win version
To Next Page
Loading...
