Fuji Electric FRENIC-VG Series - Page 189

6.5 SX Bus Interface Card
6-113
Chap. 6
CONTROL OPTIONS
[ 1 ] System definition window
In system definition, you construct the system using the SX bus, configure the entire system for operation,
configure operation, and configure individual modules. Double-click the [System_Definition] icon in the
[Physical Hardware] configuration subtree to open the system configuration definition screen.
Figure 6.5.28
[ 2 ] Adding a module
 If the transmission format settings are different, a heavy alarm occurs and communication is not available. Be
sure to check the following for the correct settings.
For the MICREX-SX series
, it is necessary to register all the modules (including the inverter) to use in the
system configuration definition of the PC system.
To add the module (inverter), right-click the base module on the system configuration definition tree, and
select [Insert] to open the [Module insert] dialog box.
Figure 6.5.29
System Configuration Definition Tree
Set the SX bus
stat
i
o
n
add
r
ess
.
Set each item and click the [OK] button.
Module attribute: Individual module
Module t
yp
e: Select the inverter.
Select the transmission format of FRENIC-VG.