6.12 DIO Expansion Card
6-233
Chap. 6
CONTROL OPTIONS
6.12.4.2 Basic schematic diagram (DIOB)
Only the use of the OPC-VG1-UPAC as another option (available soon) will make it possible to operate
the I/O points of the DIO expansion card.
Table 6.12.5 shows the plug pin arrangement.
Figure 6.12.5
Pin no. Name Function Pin no. Name Function
[1] CM Common (M24) [13] Y21 Control output Y21
[2] X21 Control input X21 [14] Y22 Control output Y22
[3] X22 Control input X22 [15] Y23 Control output Y23
[4] X23 Control input X23 [16] Y24 Control output Y24
[5] X24 Control input X24 [17] Y25 Control output Y25
[6] CM Common (M24) [18] CME Output common
[7] X25 Control input X25 [31] Y26 Control output Y26
[8] X26 Control input X26 [32] Y27 Control output Y27
[9] X27 Control input X27 [33] Y28 Control output Y28
[10] X28 Control input X28 [34] Y29 Control output Y29
[11] - Not connected [35] Y30 Control output Y30
[12] - Not connected [36] CME Output common
[19] CM Common (M24)
[20] X29 Control input X29
[21] X30 Control input X30
[22] X31 Control input X31
[23] X32 Control input X32
[24] CM Common (M24)
[25] X33 Control input X33
[26] X34 Control input X34
[27] X35 Control input X35
[28] X36 Control input X36
[29] - Not connected
[30] - Not connected
Figure 6.12.10
Figure 6.12.11
Note: The shielded wire should be basically earthed. If strong inductive noise interferes with the FRENIC-VG,
however, the influence of the noise may be suppressed by connecting the shielded wire to the 0-V line.
OPC-VG1-DIO,SW2=DIOB
MOTOR
FRENIC-VG
Main power supply
3-phase power supply
50/60 Hz
E
U
V
W
M
[TH1]
[THC]
NTC thermistor
U
V
W
L1/R
L2/S
L3/T
PG
[PGP]
[PGM]
[PA]
[PB]
SS,E
[X21]
[X22]
[X23]
[X24]
[CM]
[13]
[14]
[15]
[16]
[17]
[31]
[32]
[33]
Y21
Y22
Y23
Y24
Y25
Y26
Y27
Y28
[18][36]
[P24]
[M24]
[P24]
[M24]
CN24 or
CN25
E
[CME]
[2]
[3]
[4]
[5]
[1]
[X25]
[X26]
[X27]
[X28]
[CM]
[7]
[8]
[9]
[10]
[6]
[X29]
[X30]
[X31]
[X32]
[CM]
[20]
[21]
[22]
[23]
[19]
[X33]
[X34]
[X35]
[X36]
[CM]
[25]
[26]
[27]
[28]
[24]
[34]
[35]
Y29
Y30
OPC-VG1-UPAC
19 21
20 22
23 25
24 26
27 29
28 30
31 33
32 34
1 3
2 4
5 7
6 8
9 11
10 12
13 15
14 16
35
36
17
18
Viewed from the soldered pin side of the plug