Fuji Electric FRENIC-VG Series - Check Functions; Option Installation Check; I;O Check

6.11 DI Interface Card
6-225
Chap. 6
CONTROL OPTIONS
6.11.6 Check functions
6.11.6.1 Option installation check
You can check on the keypad whether the DI interface card is set
to DIA or DIB.
From the Operating Mode screen, go to the Program Menu
screen and select "4. I/O check." Use the
and keys to
switch screens and check the screen corresponding to the DI
interface card.
For more information, see the section on keypad operation.
If the card is set to DIA,  will change to  on the LCD screen, as shown in the sample to the right.
6.11.6.2 I/O check
You can check the DI interface card's digital input status on the
inverter's keypad. From the Operating Mode screen, go to the
Program Menu screen and select "4. I/O check." Use the
and
keys to switch screens and check the screen
corresponding to the DI interface card.
Input data is displayed as "XXXXX" in the screenshot to the right.
For example, an indication of "A = 4000" would indicate BCD input of 4000.
ＯＰ―Ａ：ＶＧ１－ＤＩＡ
ＯＰ－Ｂ：
ＯＰ－Ｃ：
∧∨ÆＰＡＧＥ ＳＨＩＦＴ ９
■ＤＩＡ ■ＢＣＤ □ＢＩＮ
Ａ ＝×××××
□ＤＩＢ □ＢＣＤ □ＢＩＮ
Ｂ ＝×××××
∧∨ÆＰＡＧＥ ＳＨＩＦＴ １８