Fuji Electric FRENIC-VG Series - 6.15.11 Support Tool Interface; 6.15.11.1 Configuration Definition Method; 6.15.11.2 Compatible Versions of the SPH3000 MM and Support Tool

6.15 E-SX Bus Interface Card
6-267
Chap. 6
CONTROL OPTIONS
6.15.11 Support tool interface
6.15.11.1 Configuration definition method
The configuration definition method in the "Expert (D300win)" support tool for the inverter is explained
below.
1 In "E-SX bus" under "CPU" below, select the IN terminal or OUT terminal that connects the inverter,
and right-click to perform "Insert".
2 In the "Module insert" window, select the individual module in "Module attribute type", select the
inverter in "Module group type", and select model "FRN-VG1 (STD1)" in "Outline specification".
3 Parameter settings are not necessary (parameters cannot be set). Press OK.
6.15.11.2 Compatible versions of the SPH3000MM and support tool
(1) Compatible versions of the inverter support tool are as follows.
 Expert (D300win) : V3.5.2.36 or later
 Standard : V3.0.3.34 or later
(2) Compatible versions of the inverter SPH3000MM are as follows.
 Hardware : V20 or later
 Firmware : V02 or later