6.1 Common Specifications
6-13
Chap. 6
CONTROL OPTIONS
Installation procedure 1 (when not using the option together with a digital 16-bit
option card)
(1) Attach the three included spacers (d) to the three option mounting fixtures (a) through (c) on the
control printed circuit board.
(2) Install the analog option card so that connector CN1 (on the back of the analog option card) connects
to A port (CN3) on the control printed circuit board.
(3) Connect the power supply harness running from the top of the analog option card to CN12 on the
control printed circuit board.
(4) Tighten the three included screws (e) to secure the analog option card in place.
(5) Referring to Figures 6.1.2 and 6.1.3 "Removing the Front Cover," reverse the removal procedure to
mount the front cover.
Figure 6.1.12 Installing an Analog Option Card
A port
e
c
a
b
d
nalog option card
Control printed
circuit board
CN12
d
Power supply
harness
e
To Next Page
Loading...
