Fujitsu PRIMERGY TX100 S3 Core Edition - Concluding Steps

TX100 S3 Core Edition Upgrade and Maintenance Manual 229
Cabling
Ê Connect the new SATA power cable to the HDDs.
I P4 is used for HDD 1
P5 is used for HDD 2
P3 is used for HDD 3
P2 is used for HDD 4
15.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section "Installing the side cover" on
page 56.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 57.