Fujitsu PRIMERGY TX100 S3 Core Edition - Concluding Steps; Storing Not Used SATA Data Cables

232 Upgrade and Maintenance Manual TX100 S3 Core Edition
Cabling
15.3.4 Concluding steps
Perform the following procedures to complete the task:
Ê Insert the HDD cage as described in section "Installing the HDD cage" on
page 62.
Ê Close the side cover as described in section "Installing the side cover" on
page 56.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 57.
15.4 Storing not used SATA data cables
Figure 152: Securing not used SATA cables
I If only two hard disk drives are installed, secure the unused SATA data
cables in the cable clamps as shown in the figure.