Fujitsu PRIMERGY TX100 S3 Core Edition Upgrade And Maintenance Manual

198 Upgrade and Maintenance Manual TX100 S3 Core Edition
System board and components
14.2.1.2 Preliminary steps
Before replacing the system board, perform the following steps:
Ê Shut down the server as described in section "Shutting down the server" on
page 40.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section "Disconnecting the power cord" on page 41.
Ê Disconnect all external cables.
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section "Removing the side cover" on
page 43.
Ê Remove the HDD cage as described in section "Removing the HDD cage"
on page 60.
14.2.1.3 Removing the system board
Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see section "Removing the processor heat sink" on page 131
I Leave the processor on the defective board for now.
– Memory modules: refer to section "Removing memory modules" on
page 125
I Ensure to take note of the memory modules’ mounting positions
for reassembly.

Fujitsu PRIMERGY TX100 S3 Core Edition Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3 Core Edition
Category	Server
Language	English