Fujitsu PRIMERGY TX100 S3 Core Edition - Removing a 3.5-Inch HDD; Installing a 3.5-Inch HDD; Concluding Steps

98 Upgrade and Maintenance Manual TX100 S3 Core Edition
Hard disk drives
7.4.3 Removing a 3.5-inch HDD
Ê Remove the HDD to be replaced from the server as described in section
"Removing 3.5-inch HDDs" on page 93.
7.4.4 Installing a 3.5-inch HDD
Ê Install the new HDD into the empty drive bay as described in section
"Installing 3.5-inch HDDs" on page 85.
7.4.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section "Installing the side cover" on
page 56.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 57.
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 71.