Fujitsu PRIMERGY TX100 S3 Core Edition - Concluding Steps

92 Upgrade and Maintenance Manual TX100 S3 Core Edition
Hard disk drives
Figure 44: Connecting SATA cables to HDDs 3/4
Ê Connect the SATA cable connected to system board connector SATA 3 to
HDD 3 (1).
Ê Connect the SATA cable connected to system board connector SATA 4 to
HDD 4 (2).
Ê For further cabling information, please refer to section "Cabling" on
page 217.
7.2.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section "Installing the side cover" on
page 56.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 57.
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 71.
/
0