Revision 1 176 9/10/2019
Sensing Tape
Installation, 43
Sensor Block, 23
Sensor Calibration Alarm, 82
Sensor Comm Alarm, 81
Sensor LED Current, 77
Sensor LED Current Alarm, 81
Sensor LED current alarm limit is, 98
Sensor Temperature, 77
Sequencer Items, 114
Sequencer State, 77
Sequencer Tab, 113
Serial Port, 117
Service, 160
Set Background Colour, 86
Set Communication Parameters, 39
Set Trace Colour, 86
Show Statistics, 86
SI, 56
soft keys, 55
Software
Installation, 36
Solenoids, 112
Specifications, 179
SQNC Menu, 63
Stain Appearance, 52
Stain Width, 96
Stain Width per Pulse, 96
Standard Analysis, 13
Status Bar, 74
Status Indicator Lines, 56
Status Tab, 79
Stream Calibration Used, 104
Stream menu, 57
Streams Menu, 60
Streams Tab, 99
STRM, 57
Supply and Take-up Reels, 19
Switching Field, 103
Synchronize Time, 72
System Menu, 70
T
TA, 56
Table Format, 83
Tabs, 73
Take-up Reels, 19
TAPE, 65
Tape advance, 56
Tape Advance, 72
Tape Field, 96
Tape Length Alarm, 81
Tape Length Limit, 98
Tape Movement Alarm, 81
Tape Remaining, 77
Tape Saturation Cut-off (TSC), 102
Tape Transport System, 19
Temporary Write to Analyzer, 72
Testing the Analyzer, 52
Timed Analysis, 13
Timed Analysis Enable, 101
Timers Tab, 126
Timing Commands, 101
Tool Bar, 71
Trend Filter Length, 96
Trended Reading, 77
Troubleshooting Messages, 160
U
Universal Gas Run Commands, 101
Unpacking, 35
Update mode, 42
Update Mode, 70
Update Mode command, 69
Upgrade Firmware, 72
V
Validating the Analyzer Outputs, 142
View Menu, 70
W
Warranty, 11
Wiring Book, 170
Write Current Page to Analyzer, 75
Z
Zero Correction Enable, 101
zero offset, 61
Zero Offset, 77, 101
Zero Tab, 106
To Previous Page
Loading...
