Revision 1 30 9/10/2019
The optional sample conditioning system is typically mounted on the sample panel to the right
of the analyzer.
3.2.4 Area Classification Information
Class 1, Division 2, Groups B, C & D, T3
3.2.5 Gas Requirements
If the analyzer is not provided with a sample conditioning system, the sample gas needs to be
clean and regulated at 15-20 psig.
3.3 Unpacking
To unpack the system:
a) Open the shipping container and remove all packing material and boxes. Visually inspect
the system and accessories package(s) to ensure that no damage has occurred. If
damage has occurred, save all packing material and contact the shipping company as
well as Galvanic Applied Sciences.
If any damage is visible, do not proceed with the system installation. Do not attempt to
facilitate repairs yourself as this will negate and/or invalidate any possible insurance
claims or equipment warranty.
b) Place the small packages aside in a safe, secure storage area as they are not needed at
this stage of the system installation.
To Next Page
Loading...