Rev. AV Page 16-38
THE AIRFRAME'S STOPS SHOULD LIMIT MOTION BEFORE THE SERVO CRANK ARM
CONTACTS THE STOP BRACKET.
NOTES:
BRACKET LOCATION IS SHOWN CENTERED OVER 3, 4, 5, & 6 PRE-PUNCHED1.
RIVET HOLES AFT OF THE BELL CRANK PIVOT. THIS IS THE RECOMENDED BRACKET
LOCATION. DIMENSION IS SHOWN FOR REFERENCE ONLY.
ATTACH MOUNTING BRACKET TO AIRFRAME FLOOR RIB USING A MINIMUM 2.
OF TWO ROWS OF FOUR AN470 4-X RIVETS SPACED A MINIMUM OF 1" APART.
RIVETS ARE NOT INCLUDED IN SERVO MOUNTING KIT.
STOP BRACKET SHOULD NOT BE USED AS THE PRIMARY MEANS OF LIMITING MOTION.3.
RECOMMDNED STOP BRACKET ORIENTATION
2.5
HOLE FOR AN3 BOLT
(#12 DRILL BIT)
SCALE 1:1
SEE NOTE 1 & 2
BELL CRANK PIVOT
(2.66)
SEE NOTE 1
SEE NOTE 3
To Next Page
