Garmin G3X - Page 199

190-01115-01 G3X™/G3X Touch™ Avionics Installation Manual
Rev. AV Page 16-39
Figure 16-14.1 GSA 28 RV-10 Pitch Mounting Kit 011-02952-15 (page 1 of 2)
011-02951-00 STOP BRACKET KIT (INCLUDED WITH GSA28) SEE NOTES 7 & 8
NOTES:
DIMENSIONS: INCHES
1.
DIMENSIONS ARE NOMINAL AND TOLERANCES ARE NOT IMPLIED UNLESS SPECIFICALLY STATED.
2.
HOLE MUST BE DRILLED THROUGH BELL CRANK TO ATTACH PUSH ROD. SEE SHEET 2 FOR HOLE SIZE AND LOCATION.
3.
SINGLE AN960-10 WASHER (ITEM 2) MUST BE PLACED IN-BETWEEN BELL CRANK HALVES CONCENTRIC WITH DRILLED HOLES.
4.
NOTE HAS BEEN REMOVED.
5.
NOTE HAS BEEN REMOVED.
6.
TIGHTEN #4-40 SCREWS TO 8
1 IN-LBS.
7.
STOP BRACKET SHOULD NOT BE USED AS THE PRIMARY MEANS OF LIMITING MOTION. THE AIRFRAME'S STOPS SHOULD LIMIT MOTION
8.
BEFORE THE SERVO CRANK ARM CONTACTS THE STOP BRACKET.
1
1
2
2
2
3
4
11
2
2
5
6
6
FASTEN SERVO BRACKET TO AIRFRAME PRIOR TO INSTALLING SERVO. SEE SHEET 2.
TABLE 1
DETAIL 'A'
6
7
3
2
2
SEE NOTE 4
2
PUSH ROD SHOWN IN OUTERMOST SERVO HOLE. SEE SHEET 2, NOTE 3.
DETAIL 'B'
ITEM
GARMIN P/N
QTY
DESCRIPTION
1
211-00090-01
4
AN3-5A BOLT
2
212-00035-10
14
AN960-10 WASHER
3
212-00080-03
2
AN970-3 WASHER
4
115-01854-09
1
RV-10/14 PITCH BRACKET
5
211-00090-05
1
AN3-7A BOLT
6
210-00117-03
6
AN365-1032A LOCK NUT
7
211-00090-07
1
AN3-11A BOLT
8
382-00019-02
2
MALE ROD END BEARING
9
210-00116-03
2
AN315-3R JAM NUT
10
117-00542-08
1
PUSH ROD, 3/8 DIA, 3.25" LNG, TAPPED
11
212-00043-10
1 AN960-10L (THIN) WASHER