5-14 120 Series Maternal/Fetal Monitor Revision B
2015590-001
Setup Procedures: MSpO2 Setup Screen
Averaging Time (Masimo Module Only)
This menu option only appears when using a Masimo module and sensor. Choose a
response time in order to compensate for different levels of patient activity: 2, 4, 8,
10, 12, 14, or 16 seconds.
For the 2 and 4 second averaging settings: The actual averaging times may range
from 2 to 4.
îš„ 10, 12, 14, or 16 seconds: These averaging settings are least affected by patient
movement.
îš„ 8 seconds: This averaging selection is recommended in cases where the patient
is relatively inactive.
îš„ 2, 4 seconds: These averaging selections are most affected by patient
movement.
Print Interval
This setting determines the time interval for printing the MSpO2 values on the strip
chart paper.
%O2 Trace
This setting enables or disables the printing of the %MSpO2 trend on the bottom grid
of the strip chart paper.
îš„ On: The %MSpO2 trend prints in grey and is annotated with %MSpO2 .
îš„ Off: The %MSpO2 trend is not printed.
Alarm Limits
These fields adjust the high and low alarm limits for %MSpO2, as well as for MHR/
P—in increments of 1% or 5 BPM.
Audio Alarm
This field enables/disables the audio alarm function for MSpO2.
îš„ On: Visual and audible indications are provided during an MSpO2 alarm
condition.
îš„ Off: Only a visual indication is provided during an MSpO2 alarm condition.
Alarm Volume
This field controls the alarm volume.
To Next Page
Loading...
Need help?
General
