2-2 120 Series Maternal/Fetal Monitor Revision B
2015590-001
Introduction: Indications for Use
Indications for Use
Fetal Monitoring
A Corometrics 120 Series Monitor can be used for routine non-invasive and
invasive fetal monitoring throughout labor and delivery (i.e. fetal heart rate and
uterine activity monitoring) Fetal movement detection and fetal heart rate alarm
options (user selectable high/low and poor signal quality alarms) are available.
Maternal Monitoring
A Corometrics Model 128 or 129 Maternal/Fetal Monitor is intended for monitoring
maternal vital signs to help assess maternal well-being. The vital signs which can be
measured with either of these monitors are summarized below.
IMPORTANT– Maternal vital signs provided by the monitor
should only be used as an adjunct to patient assessment and must
be used in conjunction with clinical signs and symptoms.
Blood Pressure
This parameter is intended for use in the non-invasive monitoring of maternal blood
pressure (NBP). This monitor is not intended for use in neonatal or pediatric blood
pressure monitoring.
Pulse Oximetry
This parameter is intended for use in the non-invasive monitoring of the functional
oxygen saturation of maternal arterial blood (MSpO
2).
Heart/Pulse Rate
NOTE: A Model 128 provides
maternal pulse rate data derived from
the NBP and MSpO
2 sections of the
monitor. Only a Model 129 provides
both maternal heart rate and maternal
pulse rate data; the heart rate data is
derived from the MECG section of the
monitor while the pulse rate data is
derived from the NBP and MSpO
2
sections of the monitor.
This parameter is intended for use in the non-invasive monitoring of the maternal
heart/pulse rate (MHR/P).
To Next Page
Loading...
Need help?
General
