Revision B 120 Series Maternal/Fetal Monitor 5-31
2015590-001
Setup Procedures: Service Mode Screens
Fetal Alert/Alarms
If the Spectra Alerts option is installed in your monitor, use this field to select
between the built-in FHR alarm features of the monitor and the Spectra Alerts
option.
îš‹ Alarms: The monitor generates alarms based on the limit settings provided
on the FHR setup screens.
îš‹ Alerts: Enables the Spectra Alerts feature to analyze heart rate and uterine
activity data to detect certain abnormal trends and alert the clinician.
Alert Suspend
When a care provider is at the patient’s bedside, it may be desirable to suspend the
audio component of alerts.
îš‹ Off (disabled): users are unable to suspend audio alerts.
îš‹ On (enabled): users can manually activate/de-activate the function.
Printing System Setup Information
Use the Trim Knob control to select the PRINTALL softkey on the bottom of the Install
Options screen to see an overall summary of the monitor’s setup screens. A screen
capture of each system setup screen (user and service) is printed on the strip chart
paper. The following screen summaries are printed:
îš„ Diagnostic Control
îš„ Communications Setup
îš„ Install Options
îš„ General Setup
îš„ Master Alarm Setup
îš„ Vital Signs History
îš„ FSpO2 Setup
îš„ MSpO2 Setup
îš„ MHR/P Setup
îš„ NBP Setup
îš„ FECG Setup
îš„ US Setup
îš„ US2 Setup
NOTE: The FECG, US, and US2 Setup screens are shown together in one group.
In addition, the HR Offset field is separated on this summary screen, since
it may appear on either the US or the US2 Setup screen—depending on the
active connectors.
To Next Page
Loading...
Need help?
General
