EasyManua.ls Logo

GE Senographe DS

GE Senographe DS
1810 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page no. 1769 Chapter 11
SC-PM-A-001.fm
GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Scenario PM A001 - Planned Maintenance Steering Guide
4 PM TASK SCHEDULE (VISITS 1-6)
Note:
Some of the tasks listed in this schedule may overlap with similar tasks required by your local regulations. If this is the case you
can skip these particular tasks and perform the tasks required by your local regulations instead.
Task Title Task Definition Int.
mth.
Drn.
min.
PM Visit no.
123456
Inspection:
General system inspection checks Perform a general inspection of the entire system.
See Job Card PM A155 - General System Inspec-
tion Checks on page 1775.
6 10XXXXXX
Generator/Tube:
Remove Generator Covers. Job Card PHY A042 - Remove/Reinstall Genera-
tor Covers: p. 513
6 5 XXXXXX
Clean Conditioner Air Filter Job Card PM A429 - Conditioner Air Filter Clean-
ing: p. 1807
6 5 XXXXXX
Check and top-up Conditioner coolant Job Card PM A428 - Conditioner Coolant Level
Check and Top-up: p. 1805
6 5 XXXXXX
Change Generator CPU Lithium Battery Job Card D/R A402 - Generator CPU Battery: p.
1549
36 25 X
Check HV Unit Job Card PM A407 - Check HV Unit: p. 1801 12 5 X X X
Check Half Value Layer (HVL) Job Card CAL A046 - Half-Value Layer Measure-
ment: p. 1703
12 10 X X X
Check kVp settings Job Card CHK A011 - Check kVp settings: p.
1745
12 5 X X X
Check mA and mAs settings Job Card CHK A013 - Check mA and mAs set-
tings: p. 1755
12 30 X X X
Reinstall Generator covers. Job Card PHY A042 - Remove/Reinstall Genera-
tor Covers: p. 513
6 5 XXXXXX

Table of Contents

Other manuals for GE Senographe DS

Related product manuals