GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Job Card ELE A020 - Declare and Set Printers (Filming Devices)
Page no. 619 Chapter 7
JC-ELE-A-020.fm
4. In the fields Ambient Room Light and Light Box Light, type the values corresponding to the printer
you will use in this review room (see table below).
Use the Clear button if you need to reset the values you entered.
5. Click the Save button.
The new review room name appears in the Review Room Selection window.
6. Click the Cancel button to close the Review Rooms Parameters window.
Printer Model Ambient Room Light Light Box Light
Carestream 5850 (see Note 2) 10 5000
Carestream 6850 (see Note 2) 10 5000
Kodak 6800 (see Note 2) 10 5000
Kodak 8900 (see Note 2) 10 5000
Kodak 8600 10 5000
Kodak 8610 10 5000
Konica 793 1 4000
Konica 873 1 4000
Agfa 4500 M 10 4000
Agfa 5500 10 4000
Agfa 5503 10 4000
Agfa AXYS 1 4000
Fuji DryPix 4000 10 4000
Fuji DryPix 5000 10 4000
Fuji DryPix 7000 10 4000
SONY UP-DF750 10 4000
Fuji DryPix FMDPL 1 2300
Note 1: If your printer is not listed in this table then contact your GEMS Service Representative for
the recommended values for your printer.
Note 2: To match new AFSSAPS requirements (in France) for Ambient Light=1 & Illumina-
tion=4000, do not set Review Room into Review Room Management, and check with the printer
manufacturer that the printer is correctly configured.
To Next Page
Loading...
Need help?
General
