GE Voluson E6

GE HEALTHCAREDRAFT VOLUSON E8 / VOLUSON E6
D
IRECTION KTD102576, REVISION 7 DRAFT (AUGUST 23, 2012) SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-37
File Decompress Error. Action: Load volume files from other storage medium. load volume files from other storage medium
File Decompress method Unknown.
Action: Load volume files from other storage medium.
load volume files from other storage medium
File End Error. Action: Load volume files from other storage medium. load volume files from other storage medium
File Memory Missing. Action: Load volume files from other storage medium. load volume files from other storage medium
File Not Found. Action: Load volume files from other storage medium. load volume files from other storage medium
File Pos. Action: Load volume files from other storage medium. load volume files from other storage medium
File Read Error. Action: Load volume files from other storage medium. load volume files from other storage medium
File Type Unknown. Action: Load volume files from other storage medium. load volume files from other storage medium
File Volume size not consistent.
Action: Load volume files from other storage medium.
load volume files from other storage medium
FilterBuffer " Memory allocation failed". Action: please restart the system restart the system
GeckoBF: Wave Form Table wasn't found! Unknown Wave Form Table Key!
Action: Restart the System!
restart the system
GeoDescription3D_TissueCF::operator=: handed over argument is not of same
type, dynamic cast failed!!
restart the system
GeoDescriptionMotion Constructor: unknown mode Parameter handed over restart the system
GeoDescriptionMotion::operator=: handed over argument is not of same type,
dynamic cast failed!!
restart the system
GeoDescriptionPWMode::operator=: handed over argument is not of same type,
dynamic cast failed!!
restart the system
GeoDescriptionTissueCF Constructor: unknown mode Parameter handed over restart the system
GeoDescriptionTissueCF::operator=: handed over argument is not of same type,
dynamic cast failed!!
restart the system
Hardware doesn't support CW-mode
pencil probe + CW-Hardware not available->
restart the system
hardware error on <var> Action: restart the system restart the system
HardwareRelatedSoftware_Windows in write have different ProbeAcousticUnitIDs.
Action: disconnect all connected probes and connect again,
if not ok restart the system
disconnect all connected probes and connect them again;
if not ok restart the system
HardwareRelatedSoftware_Windows in write have different ProbeScanFuncIDs.
Action: disconnect all connected probes and connect again,
if not ok restart the system
disconnect all connected probes and connect them again;
if not ok restart the system
IBegrenzer.cpp BCshots no TxPulseEntrys.
Action: restart the system, If after restart not ok then call technical support
restart the system
IBegrenzer.cpp Bshots no TxPulseEntrys.
Action: restart the system, If after restart not ok then call technical support
restart the system
IBegrenzer.cpp Bshots TxMultiFocus problem restart the system
Error Messages Actions