GEM Hemochron 100 - Page 50

4 - Patient Testing
50 / 112
000HZ6006EN.US • 02 • GEM Hemochron 100 Operator Manual
To Enable the Test Interval Timer Feature:
NOTE: The Interval Timer setting must be set to (Show) to use the Test Interval Timer feature.
To congure Interval Timer setting, see “Interval Timer” (page 27).
1 On the Home screen, select (Information), then change the status from (Disabled) to (Enabled).
See Figure 53 .
Figure 53 : Test Interval Timer Feature – Disabled to Enabled
2 In the dialog box ( Figure 54 ), scroll the Minutes for Notication Time to select the duration or manually
enter the value (touch the text eld to display virtual keyboard).
Figure 54 : Test Interval Timer – Notication Time
3 (Optional) Scroll down ( Figure 55 ) and use the toggle to select On or O󰀨 for the following options:
● Beep:
– On (Toggle On) – Enabled (the notication is accompanied by 1 audible beep).
– O󰀨 (Toggle O󰀨) – Disabled (the notication is NOT accompanied by an audible beep).
● Repeat:
– On (Toggle On) – Enabled (the audible beep will be repeated every minute until the
notication is acknowledged by the Operator ).
– O󰀨 (Toggle O󰀨) – Disabled (the audible beep is NOT repeated).
Figure 55 : Test Interval Timer – Beep Options
4 Select Ok.