Getinge 1009.25B0 - User-Defined Sequences; Creating, Editing, and Deleting Folders for User-Defined Sequences; Save a User-Defined Sequence

5
Operating menu
[OR table positions] menu
58 / 92
1009.25B0
IFU 1009.25 EN 01
5.5.3 User-defined sequences
NOTIC E
Depending on the connected operating table, the function USER-DEF.
ADJUSTMENT SEQUENCES may not be available. For further information, refer
to the operating table operating instructions.
NOTIC E
If the operating table has a body elevator, we recommend always extending it at
the end of a sequence.
NOTIC E
The following adjustments cannot be saved and approached using the function
USER-DEF. ADJUSTMENT SEQUENCES:
• Height
• Longitudinal shift
• Lateral shift
If the operating table will be moved into the desired position in a certain sequence, then this se-
quence can be saved via this menu to be made available for access later on.
5.5.3.1 Creating, editing, and deleting folders for user-defined sequences
Folders for user-defined sequences are created, edited and deleted as described in the section
Creating, editing, and deleting folders for user-defined sequences [8Page51].
5.5.3.2 Save a user-defined sequence
OR01-14
CREATE NEW
SEQUENCE
BACK
USER-DEF. ADJUSTMENT SEQUENCES
EDIT EDIT
Folder 01
Folder 02
1
Dr. Kruger
Dr. Kruger_02
Folder 03
Fig.62: Save new sequence
Create a new sequence and save it in a list
Prerequisites:
• The USER-DEF. ADJUSTMENT
SEQUENCES menu is open.
• The table top is aligned horizontally
[8Page63].
1. Touch the CREATE NEW SEQUENCE
button 1 .
Ø The window for creating a new se-
quence is opened.