78
Possible configurations with the PC software “Digta Configurator”
Possible configurations with the PC 8.
software “Digta Configurator”
Configuration software8.1
The Digta Configurator configuration software is a tool from Grundig
Business Systems for adjusting your dictation machine to your personal
working requirements and to the optimal workflow for your company.
Digta Configurator can be used for the following purposes:
Reading dictation machine information•
General configuration of the dictation machine•
Personalizing your dictation machine•
Extending the functions of your dictation machine•
Connect the dictation machine to the PC using the USB cable and start
the Digta Configurator. The setting options for your Digta are listed in the
“Detected devices” directory of the Digta Configurator.
Further details on installation and use of the Digta Configurator can
be found in the “Digta Configurator” operating instructions.
8.2 PIN/PUK
Your Digta is equipped with a PIN/PUK function. Activating the PIN (per-
sonal identification number) protects your machine against unauthorized
use. Use a number combination that is known only to you as your pin.
The factory setting of the PIN is 0000. You can change this PIN with-
in a menu function (see section “Menu functions/Device settings/
Change PIN”).
You must enter the PIN each time the device is switched on and when
activating it out of sleep mode. Only then can the device be operated.
You can activate the PIN using the PC software included with delivery
or you can contact the service hotline. The contact information can be
found on the internet at:
www.grundig-gbs.com
Dictations on external, removable memory cards (Digta Card) can not
be protected through the PIN/PUK function.
When changing to an external memory card a prompt appears. Con-
firm that you would like to work with an external memory card with-
out PIN protection.
Digta Configurator
PIN factory settings
External memory without PIN protection
To Next Page
Loading...
Need help?
General
