GW Instek LCR Series - Measurement Function [FUNC]; Test Mode [MODE]; Figure ‎ 4 -5 [LIST SETUP] Page

Measure Key
42
Figure 4-5 [LIST SETUP] Page
4.3.1 Measurement Function [FUNC]
Select the primary and the secondary measurement here.
4.3.2 Test Mode [MODE]
The [LIST MEAS] page will execute a list of up to 10
swept frequency or amplitude tests.
When [MODE] is set to SEQ and [TRIG] is set to
MAN, the [LIST MEAS] function will automatically
execute each test step on the list in sequence until the
last step is executed. The meter will then wait for the
trigger button to be depressed before repeating the
process.
When [MODE] is set to STEP and [TRIG] is set to
MAN, the [LIST MEAS] function will automatically
execute the first test step. The meter will then wait for
the trigger button to be depressed before executing the
next step. This process is repeated for each step on the
list.
Soft-key
Function
SEQ
Sequence measure all step by one
trigger.
STEP
Measure one step by one trigger.
There are 4 available trigger modes in the [LIST MEAS]
page.
All manuals and user guides at all-guides.com
all-guides.com