GW Instek LCR Series - Default Set

LCR-6000 Series User Manual
75
6.1.10 DEFAULT SET
To reset setting values (MEAS SETUP) and offset values
(OPEN SHORT) to factory default, use the DEFAULT
SET setting. The device can be quickly restored to its
factory settings.
Default settings:
(MEAS SETUP):
FUNC: Cp-D
FREQ: 1kHz
LEVEL: 1V
RANGE: AUTO
TRIG: INT
SPEED: SLOW
SRC RES: 100Ω
BIAS: OFF
AUTO LCZ: OFF
DELAY: 0ms
ALC: OFF
AVG: 1
MON1: OFF
MON2: OFF
(OPEN SHORT):
OPEN TEST: ON
SHORT TEST: ON
SPOT: OFF
To reset setting values to factory default:
Step 1. Press the [Measure] or [Setup] key.
Step 2. Press the [SYSTEM] bottom soft-key.
Step 3. Use the cursor key to select the
[DEFAULT SET] field.
Step 4. Use the soft-keys to set.
Soft-key
Function
ON
To reset to default factory settings
OFF
No reset to factory default settings
All manuals and user guides at all-guides.com