GW Instek LCR Series User Guide

LCR-6000 Series User Manual
43
Trigger Mode
Function
INT
Trigger by the meter’s internal trigger
source.
MAN
Trigger by pressing the trigger
button.
EXT
Trigger by sending a signal to the
trigger pin on the handler interface.
BUS
Trigger by the RS-232 port.
4.3.3 List Measurement Parameters
The list parameter used for the list measurement can be
the measurement frequency or the signal level [V/A].
Use the list point field to specify the list measurement
parameter.
To specify the list sweep measurement parameter
Step 1. Press the [Measure] key.
Step 2. Press the [LIST SETUP] soft-key.
Step 3. Use the cursor key to select FREQ or VOLT
or CURR field.
Step 4. Use the soft-keys to select list measurement
parameter.
Soft-key
Function
FREQ
Uses frequency as the list
measurement parameter
VOLT
Uses voltage as the list measurement
parameter
CURR
Uses current as the list measurement
parameter
All manuals and user guides at all-guides.com

GW Instek LCR Series Specifications

General

Brand	GW Instek
Model	LCR Series
Category	Measuring Instruments
Language	English