GW Instek LCR Series - Safety Guidelines

Table of Contents
2
3. STARTUP............................................................................................21
3.1 Front panel ........................................................................................ 21
3.2 Rear Panel ......................................................................................... 22
3.3 Power On/Off ................................................................................. 22
3.3.1 Power On .................................................................................. 22
3.3.2 Power Off ................................................................................. 22
3.4 Warm‐up Time ................................................................................. 23
3.5 Connect to the Device Under Test (DUT) ................................... 23
4. MEASURE KEY ...................................................................................24
4.1 [MEAS DISPLAY] Page ................................................................. 24
4.1.1 Measurement Function [FUNC] ............................................ 25
4.1.2 Impedance Range [RANGE] ................................................. 27
4.1.3 Test Frequency [FREQ] .......................................................... 29
4.1.4 Trigger Mode [TRIG] .............................................................. 31
4.1.5 Test Signal Voltage/Current Level [LEVEL] ...................... 32
4.1.6 Measurement Speed [SPEED] ............................................... 33
4.1.7 Measurement log [LOG] ......................................................... 34
4.2 [OPEN/SHORT] Page ................................................................... 36
4.2.1 Open Correction [OPEN] ...................................................... 37
4.2.2 Short Correction [SHORT] .................................................... 38
4.2.3 SPOT Correction ..................................................................... 39
4.3 [LIST SETUP] Page ........................................................................ 41
4.3.1 Measurement Function [FUNC] ............................................ 42
4.3.2 Test Mode [MODE] ................................................................ 42
4.3.3 List Measurement Parameters ................................................ 43
4.3.4 List Point and Limit Modes .................................................... 44
4.4 [LIST MEAS] Page .......................................................................... 45
4.4.1 Trigger Mode [TRIG] .............................................................. 45
4.4.2 Test Mode [MODE] ................................................................ 46
4.4.3 Range Mode [RANGE] ........................................................... 47
4.4.4 Measurement log [LOG] ......................................................... 47
4.5 [ENLARGE DISPLAY ] Page ...................................................... 49
All manuals and user guides at all-guides.com
all-guides.com