124
OPERATION
96-8000
June 1999
PROG READY Program has been received and is ready to run.
PROGRAM END Cannot remove last EOB in program.
PROGRAM IN USE Program is already in use.
RANGE ERROR Data being entered is outside of the valid range.
RESET FIRST Must press RESET before performing this function.
RIGID TAP Rigid tapping is being performed.
RS-232 ABORT RS-232 was aborted by operator action.
RS-232 DONE RS-232 operation is complete.
RS-232 ERROR RS-232 error (shown in alarms).
SEARCHING... Searching program for requested text or G code.
SEL HI GEAR High gear selected in program.
SEL LOW GEAR Low gear selected in program.
SENDING OFFSET Sending offsets via RS-232.
SENDING PARS Sending parameters via RS-232.
SENDING SETTING Sending settings via RS-232.
SENDING VARS Sending variables via RS-232.
SENDING... RS-232 output is in process.
SERVO IS OFF When servos are off, you cannot start a program.
SERVO IS ON! Parameter change was attempted with servo on. This is dangerous!
SHUTTLE IN Tool changer is in position for a tool change.
SPEED COMD A spindle speed must be commanded.
SPINDLE CCW Spindle is turning counterclockwise.
SPINDLE CW Spindle is turning clockwise.
SPINDLE HIGH Spindle is in high gear.
SPINDLE IN USE Spindle is being controlled by program - manual controls not available
at this time.
SPINDLE LOCKED Spindle is locked in place.
SPINDLE LOW Spindle is in low gear.
SPINDLE ORI Spindle is being oriented.
SPINDLE STOP Spindle is not turning.
STRING TOO LONG The text being entered is too long.
SYSTEM ERROR Call your dealer.
TOOL CH LOCKED Tool changer has been disabled by parameter 57 bit 1.
TOOL CLAMP The tool is in the spindle.
TOOL OVERLOAD Cutting tool is overloaded.
TOOL UNCLAMP The tool has been unclamped.
TURRET IN The tool changer is in position for a tool change.
TURRET OUT The tool changer is out of position for a tool change.
WAIT OR RESET Cannot perform requested function until program finishes or RESET is
pressed.
WAIT... Requested function is being performed.
WAITING... Waiting for RS-232 input.
WRONG MODE Function requested is available only in another mode.
And the following responses, only when in graphics mode:
CIRCULAR A circular motion is being performed.
LINEAR A linear motion is being performed.
M30 FOUND End of program found and execution stopped.
M00 AFTER M06 Cannot have an M00 after M06.
NO ZOOM IN 3D Zoom is not allowed in 3D graphics mode.
RAPID A rapid motion is being performed.
To Next Page
Loading...
Need help?
General
