256
SETTINGS
June 1999
96-8000
Page Setting No: Description: Range of Value:
Name:
PROGRAM 1
2 POWER OFF AT M30 ON or OFF
31 RESET PROGRAM POINTER ON or OFF
36 PROGRAM RESTART ON or OFF
39 BEEP AT M30 ON or OFF
51 DOOR HOLD OVERRIDE ON or OFF
56 M30 RESTORE DEFAULT G ON or OFF
59 PROBE OFFSET X+ -30.0000 to +30.0000 inches
60 PROBE OFFSET X- -30.0000 to +30.0000 inches
61 PROBE OFFSET Y+ -30.0000 to +30.0000 inches
62 PROBE OFFSET Y- -30.0000 to +30.0000 inches
63 TOOL PROBE WIDTH -30.0000 to +30.0000 inches
71 DEFAULT G51 SCALING .001 to 8379.999
72 DEFAULT G68 ROTATION 0.0000 to 3599.999
73 G68 INCREMENTAL ANGLE ON or OFF
PROGRAM 2
30 4TH AXIS ENABLE OFF, S5C, 7RT, 9RT, SRT, 11RT, HA5C,
HRT160, HRT210, HRT310, 5CN, HRT450,
HRT310HA, HRT450HA, VR-A, VR-B
34 4TH AXIS DIAMETER 0 to 29.9999 inches
78 5TH AXIS ENABLE OFF, S5C, 7RT, 9RT, SRT, 11RT, HA5C,
HRT160, HRT210, HRT310, 5CN, HRT450,
HRT310HA, HRT450HA, VR-A, VR-B
79 FIFTH AXIS DIAMETER 0 to 29.9999 inches
38 AUX AXIS NUMBER 0 to 5
22 CAN CYCLE DELTA Z 0 to 29.9999 inches
28 CAN CYCLE ACT W/O X/Y ON or OFF
52 G83 RETRACT ABOVE R 0.0 to 9.9999 inches
57 EXACT STOP CANNED X-Y ON or OFF
43 CUTTER COMP TYPE A or B
44 MIN F IN RADIUS CC % 1 to 100
58 CUTTER COMPENSATION FANUC or YASNAC
85 MAX CORNER ROUNDING 0 to 0.25
PROGRAM 3
15 H & T CODE AGREEMENT ON or OFF
27 G76/G77 SHIFT DIR. X+, X-, Y+, or Y-
29 G91 NON-MODAL ON or OFF
32 COOLANT OVERRIDE NORMAL, OFF, or IGNORE
35 G60 OFFSET 0 to 0.9999 inches
42 M00 AFTER TOOL CHANGE ON or OFF
49 SKIP SAME TOOL CHANGE ON or OFF
86 M39 LOCKOUT ON or OFF
108 QUICK ROTARY G28 ON or OFF
45 MIRROR IMAGE X-AXIS ON or OFF
46 MIRROR IMAGE Y-AXIS ON or OFF
47 MIRROR IMAGE Z-AXIS ON or OFF
48 MIRROR IMAGE A-AXIS ON or OFF
80 MIRROR IMAGE B-AXIS ON or OFF
To Next Page
Loading...
Need help?
General
