Haas VF Series Operator's Manual

257
SETTINGS
June 1999
96-8000
Page Setting No: Description: Range of Value:
Name:
RS-232 PORTS
11 BAUD RATE SELECT 50, 110, 200, 300, 600, 1200, 2400, 4800,
7200, 9600, 19200, 38400, or 115200(optional)
12 PARITY SELECT NONE, ODD, EVEN, ZERO
13 STOP BIT 1 or 2
14 SYNCHRONIZATION XON/XOFF, RTS/CTS, DC CODES, or
XMODEM
37 RS-232 DATA BITS 7 or 8
24 LEADER TO PUNCH NONE, BLANK, or NUL CHAR
25 EOB PATTERN CR LF, LF ONLY, CR ONLY, or LF CR CR
41 ADD SPACES RS232 OUT ON or OFF
50 AUX AXIS SYNC XON/XOFF, RTS/CTS, DC CODES, or
XMODEM
54 AUX AXIS BAUD RATE 50, 110, 200, 300, 600, 1200, 2400, 4800,
7200, 9600, 19200, 38400, 115200(optional)
69 DPRNT LEADING SPACES ON or OFF
70 DPRNT OPEN/CLOS DCODE ON or OFF
CONTROL PANEL
6 FRONT PANEL LOCK ON or OFF
55 ENABLE DNC FROM MDI ON or OFF
76 TOOL RELEASE LOCK OUT ON or OFF
16 DRY RUN LOCK OUT ON or OFF
17 OPT STOP LOCK OUT ON or OFF
18 BLOCK DELETE LOCK OUT ON or OFF
10 LIMIT RAPID AT 50% ON or OFF
103 CYC START/FH SAME KEY ON or OFF
104 JOG HANDL TO SNGL BLK ON or OFF
84 TOOL OVERLOAD ACTION ALARM, FEEDHOLD, BEEP, PAUSE,
AUTOFEED
114 CONVEYOR CYCLE 0 - 1440
115 CONVEYOR ON-TIME 0 - 1440
EDITING
7 PARAMETER LOCK ON or OFF
8 MEMORY PROTECT ON or OFF
23 9xxxx PROGS EDIT LOCK ON or OFF
74 9xxxx PROGS TRACE ON or OFF
75 9xxxx PROGS SINGLE BLK ON or OFF
GRAPHICS
3 RESERVED N/A
4 GRAPHICS RAPID PATH ON or OFF
5 GRAPHICS DRILL POINT ON or OFF
65 GRAPH SCALE (HEIGHT) 0 to 16.250
66 GRAPHICS X OFFSET 0 to 30
67 GRAPHICS Y OFFSET 0 to 24
68 GRAPHICS Z OFFSET 0 to 16

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)