258
SETTINGS
June 1999
96-8000
Page Setting No: Description: Range of Value:
Name:
OVERRIDES
19 FEEDRATE OVERRIDE LOCK ON or OFF
20 SPINDLE OVERRIDE LOCK ON or OFF
21 RAPID OVERRIDE LOCK ON or OFF
87 M06 RESET OVERRIDES ON or OFF
83 M30 RESET OVERRIDE ON or OFF
88 RESET RESET OVERRIDE ON or OFF
The following is a detailed description of each of the settings:
1 AUTO POWER OFF TIMER
This is a numeric setting. When it is set to a number other than zero, the machine will be automatically turned
off after that many minutes of idle operation. This will not occur while a program is running and will not occur
while the operator is pressing any keys. The auto off sequence gives the operator a 30 second warning and
pressing any key will interrupt the sequence.
2 POWER OFF AT M30
This is an On/Off setting. If it is set to ON, the machine will begin an automatic power down when an M30 ends
a program. The auto off sequence gives the operator a 30 second warning and pressing any key will interrupt
the sequence.
3 RESERVED
This setting is reserved for future use.
4 GRAPHICS RAPID PATH
This is an On/Off setting. It changes what is displayed in graphics. When it is off, the rapid motions do not
leave a trail. When it is on, rapid motions leave a dashed line on the screen.
5 GRAPHICS DRILL POINT
This is an On/Off setting. It changes what is displayed in graphics. When it is off, nothing is added to the
graphics display. When it is on, any motion in the Z-axis will leave an X mark on the screen.
6 FRONT PANEL LOCK
This is an On/Off setting. When it is off, the machine operates normally. When it is on, the spindle CW and
CCW buttons are disabled.
7 PARAMETER LOCK
This is an On/Off setting. When it is off, parameters can be changed. When it is on, parameter changes are
locked out. When the control is turned on, this setting is set to On.
8 PROG MEMORY LOCK
This is an On/Off setting. When it is off, memory can be edited. When it is on, memory edit functions are
locked out.
To Next Page
Loading...
Need help?
General
