Haas VF Series Operator's Manual

268
SETTINGS
June 1999
96-8000
87 M06 RESETS OVERRIDE
This is an on/off setting. When M06 is executed and this setting is on, any overrides are canceled and set to
their programmed values.
88 RESET RESETS OVERRIDES
When the reset key is pressed and this is on, any overrides are cancelled and set to their
programmed values.
95 THREAD CHAMFER SIZE
Used in G76 and G92 threading cycles, this setting represents the number of threads (lead) that will be used
for a chamfer at the end of the thread. Values can range from 0 to 29.999 threads. Usually this is 1.000 thread.
103 CYC START/FH SAME KEY
This is an ON/OFF setting. When it is OFF, the machine operates normally. When it is ON, CYCLE START
must be pressed and held to run a program. When CYCLE START is released, a FEED HOLD is generated.
This setting cannot be ON while Setting 104 is ON. When one of them is set to ON, the other will automati-
cally turn OFF. This setting can be changed while running a program.
104 JOG HANDL TO SNGL BLK
This is an ON/OFF setting. When it is OFF, the machine operates normally. When it is ON, and SINGLE
BLOCK is selected, the jog handle can be used to single step through a program.
Reversing the jog handle direction will generate a FEED HOLD. This can be useful when an unexpected long
motion block is encountered.
CYCLE START must be used to begin running a program.
This setting cannot be ON while Setting 103 is ON. When one of them is set to ON, the other will automati-
cally turn OFF. This setting can be changed while running a program.
108 QUICK ROTARY G28
This is an ON/OFF setting. When it is ON, the G28 command will return a rotary axis only back to zero when
it has been commanded to greater than 360 degrees. For example, if a rotary axis has been commanded 361
degrees, and this setting is on, a G28 command will move it back only one degree instead of "unwinding" it all
361 degrees. Note that other G codes, such as G00 and G01, are unaffected by this setting.
109 WARM-UP TIME IN MIN.
This is the number of minutes (maximum= 300 minutes from the time the machine is powered on) to apply the
compensation. If it is set to zero no compensation will be applied.
110 WARMUP X DISTANCE
111 WARMUP Y DISTANCE
112 WARMUP Z DISTANCE
Setting 110,111 and 112 specify the amount of compensation (maximum=+/- .0020" or +/-.051mm) applied to
the X, Y and Z axis respectively. No compensation is applied if the setting is zero.
114 Conveyor cycle time (minutes)
See next entry

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)