278
PARAMETERS
June 1999
96-8000
ENABLE MACRO Enables macro functions.
INVERT SKIP Invert sense of skip to active low=closed.
HANDLE CURSR Enable use of jog handle to move cursor.
NEG WORK OFS Selects use of work offsets in negative direction.
SPIN COOLANT Enables spindle low oil pressure detection.
ENA QUIKCODE Enables conversational programming.
OILER ON/OFF Enables oiler power when servos or spindle is in motion.
NC OVER VOLT Inverts sense of over voltage signal.
DOOR STOP SP Enables functions to stop spindle and manual operations at door
switch.
Parameter 58 LEAD COMPENS SHIFT
Shift factor when applying lead screw compensation. Lead screw compensationis based on a
table of 256 offsets; each +\-127 encoder steps. A single entry in the table applies over a
distance equal to two raised to this parameter power encoder steps.
Parameter 59 MAXIMUM FEED
Maximum feed rate in inches per minute.
Parameter 60 TURRET START DELAY
Maximum delay allowed in start of tool turret. Units are milliseconds. After this time, an alarm
is generated.
Parameter 61 TURRET STOP DELAY
Maximum delay allowed in motion of tool turret. Units are milliseconds. After this time, an
alarm is generated.
Parameter 62 SHUTTLE START DELAY
This parameter is used to specify the time (in milliseconds) needed to allow the tool pocket to
settle (stop bouncing) after being lowered in preparation for a tool change.
Parameter 63 SHUTTLE STOP DELAY
Maximum delay allowed in motion of tool shuttle. Units are milliseconds. After this time, an
alarm is generated.
Parameter 64 Z TOOL CHANGE OFFSET
On Vertical mills: For Z-axis; displacement from home switch to tool change position and
machine zero. About 4.6 inches, so for an 8192 line encoder this gives:
4.6 x 138718 = 638103
On Horizontal mills, this parameter is not used. It should be set to zero.
Parameter 65 NUMBER OF TOOLS
Number of tool positions in tool changer. This number must be set to the configuration
machine. The maximum number of tool positions is 32.
To Next Page
Loading...
Need help?
General
