136 THE HASSELBLAD MANUAL
Figure 6-11 Changing a focusing screen. (1) After removing the fi lm magazine and viewfi nder,
push both screen retainers (A) into the camera body, and turn the camera upside down. The
screen will drop out easily (if it does not, push gently from inside the camera body). (2) Drop
the new screen into the square opening, with the fi nished side up. (3) Make certain that the
screen rests on all four supports (A). The screen retaining clips will close automatically when
the viewfi nder is attached to the camera.
Figure 6-12 Changing winding cranks on newer models. To remove the winding crank, push the
locking lever downward while turning the crank counterclockwise (left). To attach the crank
or motor winder, place the winder or motor with the small black triangle opposite the dot on
the camera. Turn it clockwise until it locks into position (right).
All screens must be inserted so that the fi nished side with the metal frame over the screen
surface faces up. Screens with a split image rangefi nder can be inserted so that the dividing
line in the rangefi nder is either horizontal or vertical.
Changing the Winding Cranks or Knobs
On all camera models with removable winding cranks, the crank (or knob) is best removed
and attached with the camera in the cocked position when the winding mechanism does not
rotate (Figures 6-12 and 6-13).
To Next Page
Loading...
