166 Accessories
HBM QuantumX
Transducer side
General information
Article Description Order No.
D−Sub−HD 15-pin plug set with TEDS chip Plug kit D−Sub−HD 15-pin (male) with TEDS chip for storing a
sensor data sheet; housing Metallized plastic with knurled
screws.
Note: The TEDS chip is blank.
1-SUBHD15-MALE
Port Saver D−Sub−HD 15 pin Four fully-wired male to female port savers protecting the
wear and tear of D−Sub−HD 15 pin ports for frequent
plugging and unplugging of transducers. Extends contact
durability by min. 500.
This adaptor attaches securely with screws.
1−SUBHD15−SAVE
SCM−SG120/350 SCM−SG350 Strain Bridge Module (120 Ohm or 350 Ohm)
Signal conditioning module for QuantumX full bridge input
(D−Sub−HD15 pin).
Integrated 350 Ohm bridge completion resistor, shunt
calibration, TEDS, D−Sub−HD-device connection.
Soldering point for transducer cable.
1−SCM−SG120
1−SCM−SG350
Adapter D−Sub−HD 15-pin to D−Sub 15-pin. Adapter D−Sub HD 15-pin to D−Sub 15-pin for connecting
transducers with pre−assembled D−Sub plugs on MX840
(length approx. 0.3 m)
Note: Pre-assembled for full bridge (6-wire).
1-KAB416
Push-In connector (8 Pins) 10 Push-In-connectors, Phönix Contact, 8 Pins
(Module: MX879, MX1601, MX1615)
1−CON−S1005
To Next Page
