Preventive Maintenance
Chapter 6: Cleaning and Preventive Maintenance
6 - 10 Affinity® Four Birthing Bed Service Manual (195826 REV 2)
Calf supports Check the latch/release mechanism for proper operation. Make sure that the
calf support rotates freely to make sure there is no binding. When the release
handle is rotated to the right (clockwise), the ball joint should tighten; when
rotated to the left (counterclockwise), the ball joint should loosen. Repair or
replace as necessary.
Labor grips Check that the labor grips latch correctly and are functional.
Make sure that plugs are installed in the holes on the outside of the labor grip
arms. Replace parts as necessary.
Headboard Check the headboard appearance and functionality. Replace parts as
necessary.
Mattress inspection Examine the ticking for punctures or any other type of compromise.
Examine the interior of the mattress for any contaminates.
Examine air bladders (if present) for leaks, and make sure proper air supply
connection.
Replace mattress parts such as ticking, bladders, air hose connections, etc. as
necessary.
Overall appearance Touch up the paint where necessary.
Examine the labels, and replace if necessary.
Examine the general appearance of the bed.
Examine all visible surfaces for cosmetic damage. Repair or replace parts as
necessary.
Observe the symmetry of the bed by viewing it from each corner while
looking toward the opposite corner (i.e., view from left side, foot end looking
toward right side head end). Make sure that the foot and head are not bent
out of alignment.
Examine for worn or damaged components. Replace parts as necessary.
Function Procedure
To Next Page
Loading...
