4.2 Bottom Motor Cover
Chapter 4: Procedures
4 - 4 Affinity® Four Birthing Bed Service Manual (195826 REV 2)
Figure 4-1. Top Motor Cover Assembly
REPLACEMENT
Do the removal procedure in reverse order.
4.2 Bottom Motor Cover
Tools: Ratchet T25 Torx® head bit
REMOVAL
1. Set the brake/steer pedal to the brake position.
2. Make sure the bed is out of the Trend-Like position.
3. Raise the bed to the highest position.
Failure to unplug the bed could cause injury or equipment damage.
4. Unplug the bed from its power source.
5. Put the siderail lockout switch at the head end of the bed in the locked position.
6. Remove the eight screws (A) that attach the bottom motor cover (B).
7. Remove the two screws (C) that attach the pendant control cable (D) to the bottom motor cover (B).
8. Disconnect the electrical connector (E) from the night light P.C. board (F).
9. Remove the bottom motor cover (B) from the bed.
To Next Page