Operating tabletop mechanical components
4990851_002_00 – 2082262 – 2022-01-10 35
5. Mount the inner coupling plate (3 screws).
6. Stick a new protective self-adhesive sheet onto the inner
coupling plate.
Pay attention to the positioning. The screws of the coupling
plate must be covered.
7. Restore the original cable routing.
Insert the sensor into the outer coupling plate and secure
with the threaded pin. The sensor must end flush with the
coupling plate.
8. Place the sensor cable into the opening of the outer coupling
plate and mount the two cable covers (2 screws).
9. Pull the sensor cable through the disassembled parts (sliding
washer - gear with inner coupling plate - cable housing).
10. Push the sliding washer onto the lip seal of the gear and press
in the outer coupling plate onto the gear.
Make sure the sliding washer is properly positioned. Make
sure that the sensor cable is not pinched.
11. Knock 3 pins into the gear unit at the outer coupling plate.
12. Mount the outer coupling plate (3 screws).
13. Mount the outer coupling plate on the encoding bracket (2
screws).
14. Stick a new protective self-adhesive sheet onto the outer
coupling plate.
Pay attention to the positioning. The screws of the coupling
plate must be covered.
15. Restore the original cable routing. Place the sensor cable into
the cable housing.
16. Mount the cover to the cable housing (1 screw).
Make sure that the cable does not become pinched.
17. Mount the cable housing to the drive unit for leg section (2
screws).
18. Restore the motor to its original mounting position. Mount
the motor onto the leg section gear (4 screws).
19. Mount the leg section drive unit onto the seat section bar
(Chapter 8.2).
20. Align the hinges (Chapter 16.2).
21. Mount the pad plate onto the strut (Chapter 7.2).
22. Put the pad in place.
23. Connect the power supply to the operating table
(Chapter 6.2).
To Next Page
Loading...
