Running gear mechanical parts
72
4990851_002_00 – 2082262 – 2022-01-10
11 Running gear mechanical parts
11.1 Safety
– Prior to performing any repair or maintenance work,
disconnect the operating table from the external power supply.
– Do not allow screws, nuts or other parts to fall into the
operating table. Loose parts could damage other components
or cables when adjustments are made to the operating table.
Parts that fall inside must immediately be removed. The
operating table may not be released to the customer if parts
have fallen into the operating table and have not been
removed.
– Risk of injury due to live parts or moving parts! The operating
table must be switched off while work is being carried out on it.
Switch on the operating table only when it is explicitly required.
Take extra when working on live parts and take the appropriate
safety measures. Secure the work area to prevent access by
other people.
– After performing the work, reattach all protective devices and
replace them if necessary. This includes, for example, covers,
cable ties, cable brackets, cable shields, ground/earthing and
power connections. Check the connection of the equipotential
bonding conductor / earth conductor in accordance with the
applicable standards.
– Restore the original installation position and attachment of
cables and hoses. Ensure that the cables and hoses are not
squeezed or damaged when the operating table is adjusted
(e.g. at abrasion points).
Check the cable connections against the wiring diagram and
the hose connections against the hydraulic plan before
carrying out a function test.
– There is a risk of crushing posed by falling parts when removing
bearing components.
To Next Page
Loading...
