Running gear mechanical parts
74
4990851_002_00 – 2082262 – 2022-01-10
11.3 Retractable feet on the wheel
Removal 1. Prepare the operating table (Chapter 5).
2. Disconnect the power supply on the operating table
(Chapter 6.1).
3. Turn over the operating table (Chapter 6.7).
4. Remove the screw [2] on the frame (slot screwdriver).
5. CAUTION! The spiral spring is tensioned and may unwind
erratically when released.
Remove the safety ring [3].
6. Remove the spiral spring [4].
7. Remove the retractable foot [1] from below.
Assembly 1. Insert the retractable foot.
2. Insert the spiral spring.
3. Mount the securing ring.
4. Fit the screw into the frame (slotted screwdriver).
5. Restore the operating table to the upright position
(Chapter 6.8).
6. Put the pad in place.
7. Connect the power supply to the operating table
(Chapter 6.2).
To Next Page
Loading...
