Tabletop cables
4990851_002_00 – 2082262 – 2022-01-10 99
5. Switch on the operating table using the switch at the running
gear.
6. Mount the bellows with the head-end and foot-end cover
plates on the column head.
Ensure that the cover plates fit underneath the column head
cover. Move the longitudinal slide of the operating tabletop
as necessary, so that the lateral screws on the cover plates
are accessible.
a) 5 screws at the foot end
b) 5 screws at the head end
c) 8 screws on the right side
d) 6 screws on the left side
7. Switch off the operating table using the switch at the running
gear.
8. Mount both support blocks for the extension adapter on the
column head (3 screws each).
9. Mount the column head cover (Chapter 9.3).
10. Mount the pad plate onto the strut (Chapter 7.2).
11. Put the pad in place.
12. Connect the power supply to the operating table
(Chapter 6.2).
To Next Page
Loading...
