Hioki 8730-10 - Clearing Test Modes; Setting the Beep Sound for PASS Decisions

101
_____________________________________________________________________________________________
5.2 Comparison Details
______________________________________________________________________________________________
5.2.5 Clearing Test Modes
Setting Screen: Comp
Erase Mode (MODE01 to MODE16)
NOTE
5.2.6 Setting the Beep sound for PASS decisions
Setting Screen: Comp
PASS Beep (OFF, BEEP1, BEEP2, BEEP3)
Clear the test modes to be saved in internal memory by the procedure
described in 5.2.4.
This setting is effective only when the test modes were registered.
Setting Procedure
1. Press the
COMP SETTINGS
key, select
"
Comp
" tag, then press the
ENTER
key.
2. Select "
Erase Mode
" on the display
menu, and press the
ENTER
key.
3. Use the
CURSOR
key to select a test
mode should be cleared from
"
MODE01
"to"
MODE16
" on the menu,
then press the
ENTER
key.
On the menu, the saved test modes are
shown in black. A mode must be saved
before it can be selected.
The beeper can be set to indicate the comparison results.
You can select the type of beep to sound upon PASS results.
This setting is effective only when the Beep sound setting (7.2.4) is ON.
Setting Procedure
1. Press the
COMP SETTINGS
key, select
"
Comp
" tag, then press the
ENTER
key.
2. Select "
PASS Beep
" on the display
menu, and press the
ENTER
key.
3. Use the
CURSOR
key to select a beep
sound on the menu, then press the
ENTER
key.
OFF : No beep sounds.
BEEP1: PASS results are indicated by
four short beeps.
BEEP2: PASS results are indicated by
one beep.
BEEP3: PASS results are indicated by a
long and a short beep.