Hioki 8730-10 - Basic Operation; Basic Key Operation

24
_____________________________________________________________________________________________
3.1 Basic Operation
______________________________________________________________________________________________
3.1.1 Basic Key Operation
Operating Unit
Key panel
PC Card Slot
Display
5
6
7
13
14
12
10
16
15
1
2 3
4
9
1
DISPLAY
Key
(Chapter 4)
Displays the measurement screen.
This screen lets you set parameters for waveform display,
and measurement settings.
2
COMP SETTINGS
Key
(Chapter 5)
Displays the comparison setting screen.
This screen lets you set parameters for waveform display,
area comparison, and value comparison.
3
AREA EDIT
Key (5.3.2)
Displays the area creation screen.
This screen lets you create a waveform comparison area.
4
FILE
Key (Chapter 6)
Displays the file screen.
This screen lets you save data to or read data from a PC
card.
5
WAVE SCROLL
Key
(Chapter 10)
Used to scroll back and forth across the waveform.
6
CURSOR SCROLL
Key
(Chapter 10)
Used to move or select cursors A and B.
7
ADJUST/SYSTEM
Key
(Chapter 7)
Displays the adjustment screen.
Performs various adjustments and self-checks.
8-11
CURSOR
Key (Chapter 3)
Moves the cursor.
12
ENTER
Key (Chapter 3)
Confirms the selected value.
13
STOP
Key (Chapter 3)
Interrupts ongoing measurement.
Press once to stop after finishing measurement for the set
recording length.
Press twice to abort, stopping measurement immediately.
14 POWER LED (Chapter 3)
Goes on when power is turned on.
15
START
Key (Chapter 3)
Starts measurement.
16 START LED(Chapter 3)
Stays on during measurement.
Goes off when waveform loading is complete.
3.1 Basic Operation
This section explains the basic key operations.