Hioki 8730-10 - Example of Control Via the External Control Terminals

217
_____________________________________________________________________________________________
8.6 Exam ple of Control via the External Control Terminals
______________________________________________________________________________________________
Storing
waveform
Display
processing
T
Comparison
processing
Trigger activated
(Single)
Wait for
trigger
Operation of the
8730-10 8731-10
BUSY
STORAGE
TRIG_OUT
JUDGE_OUT
MODE_SET
MODE3
～
0
M ode switching
processing
Measure-
able
START
NG_AREA
OK_AREA
Stop
ＬＬＬＬ
Storing
waveform
Display
processing
T
Comparison
processing
Trigger activated
(Repeat)
Wait for
trigger
M ode switching
processing
Measure-
able
ＬＨＬＬ
Storing
waveform
T
Comparison
processing
Wait for
trigger
Display
Processing time: less than 1s
MODE01 MODE05
Trigger activated
(Repeat)
More than 60ms
Processing time: less than 1s
More than 60ms
More than 60ms More than 60ms
Outputs cmoparison
result
Clears cmoparison
result
Outputs cmoparison
result
Clears cmoparison
result
Measurement
start
Measurement
stop
Measurement
start
8.6 Example of Control via the External Control
Terminals
This example shows a sequence that changes the test mode via the
External Control terminals while measuring.
In this example, measurements are taken in Test Modes 01 and 05.
<Control Example>
1. Perform measurement and comparison with the Test Mode 01 settings R Area Comparison FAIL
(Test Mode 01 is one-shot-trigger).
2. Perform measurement and comparison with the Test Mode 05 settings R Area Comparison PASS
(Test Mode 05 is continuous-trigger).