Hioki 8730-10 - Multi-Function Terminal (Input)

201
_____________________________________________________________________________________________
8.4 Input Terminals
______________________________________________________________________________________________
8.4.5 Multi-function terminal (Input) <EXT_IN Terminal (A14)>
HOLD
T T T
EXT_IN
OK
、
NG
、
JUDGE_OUT
EXT_IN
Comparison clear
Clears result
W
ait fo
r
tri
gg
er
Trigger activated
When function of "EXT_IN"is set to "Clear Judge-output"
Trigger activated
Trigger activated
Operation o
f
the 8730-10
8731-10
Storing
w
aveform
Evalu
-ation
Dis
p
la
y
W
ait fo
r
tri
gg
er
Storing
w
aveform
Evalu
-ation
Dis
p
la
y
Storing
waveform
Evalu
-ation
Clears result
Does not clear
com
p
arison result
W
ithin 50 ms
More than 60 ms
(
Clears com
p
arison out
p
ut
)
Starts measurement Sto
p
s measurement
More than 60 ms
More than 60 ms
When function of "EXT
_
IN" is set to "START&STOP"
START & STOP
Wait fo
r
tri
gg
er
The EXT_IN terminal (terminal No.: A14) is a multi-function terminal for
which you can select a function.
The following two functions are available:
1. Clears comparison output:
Clears comparison result output (OK, NG, or JUDGE_OUT) at the falling
signal (active LOW) of the EXT_IN terminal. Note that output is not
cleared when the HOLD terminal (terminal No.: A15) is "L."
2. START & STOP:
Starts measurement at the falling signal (active LOW) of the EXT_IN
terminal and stops measurement at the rising of an input signal (active
HIGH). Measurement cannot start when the BUSY terminal is LOW.
For information on setting the multi-function terminal, see 7.5.2.
The maximum delay from the falling or rising edge until activation is 50 ms.
Activated when a edge is detected.
Input Signal
The EXT_IN terminal (A14) inputs a signal to LOW or HIGH level
according to the function selected.
<When using an internal power supply>
HIGH level voltage: Max.: 5.0 [V], Min.: 4.0 [V]
LOW level voltage : Max.: 1.0 [V], Min: 0 [V]
<When using an external power supply>
External power supply voltage V
EXT
: Max.: 30 [V] DC, Min.: 5 [V] DC
HIGH level voltage : Max.: V
EXT
[V], Min.: V
EXT
-1.0 [V]
LOW level voltage : Max.: 1.0 [V], Min.: 0 [V]
<Timing>