Hioki 8730-10 - Chapter 8 External Control Terminals; Overview

191
_____________________________________________________________________________________________
8.1 Overview
______________________________________________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
Terminal
No.
Terminal I/O Function
Terminal
No.
Terminal I/O Function
A1 ISO_DCV -
Built-in isolated
power supply
B1 NG_VALUE
______________________
OUT
Value
comparison: FAIL
A2 EXT_DCV -
External power
supply
B2 OK_VALUE
______________________
OUT
Value comparison:
PASS
A3 EXT_COM -
Common output
terminal
B3 NG_AREA2
______________________
OUT
CH2 Area
comparison: FAIL
A4 ISO_GND -
Built-in isolated
GND
B4 OK_AREA2
______________________
OUT
CH2 Area
comparison: PASS
A5 STOP
____________
IN
Measurement
stop
B5 NG_AREA1
______________________
OUT
CH1 Area
comparison: FAIL
A6 START
______________
IN
Measurement
start
B6 OK_AREA1
______________________
OUT
CH1 Area
comparison: PASS
A7 EXT_TRIG
______________________
IN External Trigger B7 JUDGE_OUT
______________________
OUT
Comparison result
being output
A8 EXT_SAMP IN External Sampling B8 TRIG_OUT
____________________
OUT Trigger output
A9 MODE3 IN Test Mode Bit 3 B9 ERROR
______________
OUT Error detected
A10 MODE2 IN Test Mode Bit 2 B10 BUSY
____________
OUT Processing
A11 MODE1 IN Test Mode Bit 1 B11 STORAGE
____________________
OUT Measuring
A12 MODE0 IN Test Mode Bit 0 B12 EXT_OUT5 OUT
Multi-function
terminal (Output)
A13 MODE_SET
______________________
IN
Test Mode
Setting
B13 EXT_OUT4 OUT
Multi-function
terminal (Output)
A14 EXT_IN IN
Multi-function
terminal (Input)
B14 EXT_OUT3 OUT
Multi-function
terminal (Output)
A15 HOLD
____________
IN
Comparison/result
hold
B15 EXT_OUT2 OUT
Multi-function
terminal (Output)
A16 JUDGE_OFF
______________________
IN
Comparison
output stop
B16 EXT_OUT1 OUT
Multi-function
terminal (Output)
Chapter 8
External Control Terminals
8.1 Overview
Comparison results (PASS and FAIL) may be output from the external
control terminals. Moreover, these are used to control the 8730-10, 8731-10
and external sampling, and more.
Table of External Control Terminals