Hioki 8730-10 - Canceling Output of Comparison Result

203
_____________________________________________________________________________________________
8.4 Input Terminals
______________________________________________________________________________________________
8.4.7 Canceling Output of Comparison Result
<JUDGE_OFF Terminal (A16)>
T T
JUDGE_OFF JUDGE_OFFJUDGE_OFF
OK
、
NG
JUDGE_OUT
JUDGE_OFF
Check JUDGE_OFF
___________________________
Check JUDGE_OFF
___________________________
Check JUDGE_OFF
___________________________
Operation o
f
the 8730-10
8731-10
Evalu
-ation
Dis
p
la
y
W
ait fo
r
tri
gg
er
Storing
w
aveform
Evalu
-ation
Dis
p
la
y
Wait fo
r
tri
gg
er
Storing
w
aveform
Evalu
-ation
Dis
p
la
y
W
ait fo
r
tri
gg
er
Does not output comparison resultOutputs result
Outputs result Outputs result
Outputs result
Does not output comparison result
Trigger
activated
Trigger
activated
Halts the output of a comparison result.
Conducts comparison and displays the comparison result on the screen,
but does not output the result (OK, NG, or JUDGE_OUT).
The output is canceled when the JUDGE_OFF terminal (terminal No.:
A16) receives a low-level signal (active LOW).
Usually, a comparison result is output after a waveform has been loaded
and compared. If the JUDGE_OFF terminal is LOW, however, the
comparison result is not output.
Input Signal
The JUDGE_OFF terminal (A16) will be shorted with EXT_COM terminal
(A3) or a low-level signal will be input to the terminal.
The JUDGE_OFF terminal is checked when comparison has been
completed.
<When using an internal power supply>
HIGH level voltage: Max.: 5.0 [V], Min.: 4.0 [V]
LOW level voltage : Max.: 1.0 [V], Min: 0 [V]
<When using an external power supply>
External power supply voltage V
EXT
: Max.: 30 [V] DC, Min.: 5 [V] DC
HIGH level voltage : Max.: V
EXT
[V], Min.: V
EXT
-1.0 [V]
LOW level voltage : Max.: 1.0 [V], Min.: 0 [V]
<Timing>