Hioki 8730-10 - Comparison Details; Common Stop Condition

97
_____________________________________________________________________________________________
5.2 Comparison Details
______________________________________________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
5.2.1 Common Stop Condition
Setting Condition Detail
Area or Value
Stops measurement when the stop conditions for either area or value
comparison are met.
Area and Value
Stops measurement when the stop conditions for both area and value
comparison are met.
Setting Screen: Comp
Common Stop Mode (Area or Value, Area or Value)
NOTE
5.2 Comparison Details
This section explains various setting using with "
Comp
"tag.
Sets the stop conditions for waveform comparison (both area and value
comparison).
The 8730-10, 8731-10 may be set to stop measurement depending on the
area or value comparison result (PASS or FAIL). In addition, the data
may be saved depending on whether the auto save setting has been
selected. (See 4.2.9 for details.)
For the area and value comparison stop conditions, see 5.4.3, and 5.5.5.
If comparison is disabled, the system assumes that the stop conditions of the
disabled comparison are met at all times.
Setting Procedure
1. Press the
COMP SETTINGS
key, then
select "
Comp
"tag.
2. Use the
CURSOR
key to select
"
Common Stop Mode
" on the menu.
3. Use the
CURSOR
key to select a stop
condition, then press the
ENTER
key.
When the "
Trigger Mode
" is set to "
Single
", measurement continues until the stop conditions are
met and ends as soon as the stop conditions are met. When the "
Trigger Mode
"issetto
"
Repeat"or"Auto", measurement continues until the STOP key is pressed or STOP signal is
input.