Hioki 8730-10 - LAN Restart

181
_____________________________________________________________________________________________
7.3 LAN
______________________________________________________________________________________________
7.3.8 LAN Restart
Setting Screen: LAN Setting
LAN restart (ENTER)
NOTE
Enables the LAN setting.
Procedure
1. Press the
ADJUST/SYSTEM
key to
display the Adjustment screen.
2. Use the
CURSOR
key to select "
LAN
"on
"
Page
".
3. Use the
CURSOR
key to select "
LAN
restart", then press the
ENTER
key.
When the LAN cable is connected to the 8730-10, 8731-10, "
Link
" will go "
ON
" at the bottom of
the screen. If the cable (cross/straight) is improperly connected, "Link" will remain "
OFF".